Current Status

Untested.

Suggestions

Untested.

Comments

The internal SIP service needs to be disabled. You will need to use a telnet (port 23) client to connect to the IP address of this router using Putty or another telnet client. The username and password are the same as those used to access the Web UI (default username Administrator). You will need to log in to the Web UI and change the password before you can telnet into the device.

1. Open Command Prompt – “Start” → “Run” → type “cmd” and press “Enter”.
2. In Command Prompt, type “telnet 192.168.1.254” and press enter. 192.168.1.254 is the default IP address of the router. If you are running on Windows 7/8/8.1/10, you might need to install the telnet client from “Control Panel” → “Programs and Features” → “Turn Windows features on and off”.
3. The default username is “Administrator”, and there is no default password, leave blank.
4. Type “connection unbind application=SIP port=5060” and press “Enter”.
5. Type “saveall” and press “Enter”.
6. Type “exit” and press “Enter” to exit the telnet session.

**All routers and firewalls must forward the correct ports and configure Whitelisting for Hosted Voice Services; please click here for more information.